JUKI SC-510 Engineer's Manual page 39

$2 Retry function (Function setting No. 73)
When the retry function is used, if the sewing material is thick and not piereced with needle, this function
makes the needle pierce in the material with ease.
7 3
$3 With/without MF thread trimming device (Function setting No. 74)
This function sets with or without the MF thread trimming device (UT-25, etc.).
7 4
$4 One-shot function up to material end (Function setting No. 76)
This function can perform the one-shot automatic stitching up to the end of material in combination with the
material end sensor when the operation panel is not connected.
7 6
$5 Reverse feed stitching at the end of sewing start time (Function setting No. 85)
Time to run the machine at specified speed to gain back-tuck solenoid response time when moving from
end of normal sewing to reverse feed stitching is set.
8 5
Time to maintain setting No. 64 (number of
rotations of start of reverse feed stitching at the
end) immediately after entering back-tuck is set
as shown in the right-hand figure.
$6 Waiting time of start of reverse revolution to lift needle (Function setting No. 86)
Delay time from UP stop position to start of reverse revolution can be set.
8 6
$7 Function of pedal curve selection (Function setting No. 87)
This function can perform the selection of the curve of number of rotation of the sewing machine against the
depressing amount of the pedal.
Change to this function when you feel that inching operation is hard or that pedal response is slow.
8 7
0 : Normal
1
1 : Retry function is provided.
0 : Without device
1
1 : With device (Initial value)
0 : Without one-shot function
0
1 : With one-shot function
0 : Invalid
1 0
Setting range 1 to 250 [mS]
0 : Invalid
1 0
Setting range 1 to 250 [mS]
0 : Number of rotation of the sewing machine
0
in terms of the depressing amount of the
pedal increases linearly.
1 : Reaction to intermediate speed in terms
of the depressing amount of the pedal is
delayed.
2 : Reaction to intermediate speed in terms
of the depressing amount of the pedal is
advanced.
34
− −
Time of this section where
back-tuck enters is set.
2
0
Pedal stroke (mm)
1