JUKI SC-510 Engineer's Manual page 17

1 4 3
3
1 4
3
1 4
3) Number of stitches to stop the sewing machine after
detection of material end setting (Function setting
No. 4)
Press /
function setting No. 4.
It is possible to change the set value with
switch 3 or
Specified number of stitches : 0 to 19 stitches
(Caution) When the specified number of stitches
is insufficient, there is a case where the
sewing machine cannot stop within the
specified number of stitches depending on
the speed of rotation of the sewing
machine.
4) One-shot automatic stitching setting function
(Function setting No. 76)
Press /
function setting No. 76.
It is possible to change the set value with
switch 3 or
0 : Pedal designated speed is prior.
1 : Automatic operation
(Caution) 1. It is rendered effective when the
material end sensor function is set.
It is not possible to prohibit the one-
shot operation at the time of the
overlapped stitching operation.
2. Speed of rotation is the speed set
at the function setting No. 38.
a
5) Thread trimming prohibition function setting
(Function setting No. 9)
Thread trimming operation at normal stitching and
overlapped stitching can be prohibited by selecting
the thread trimming prohibition.
Press /
function setting No. 9.
It is possible to change the set value with
switch 3 or
0 : Thread trimming is effective.
1 : Thread trimming is prohibited.
a
12
− −
switch 1 to advance to the
switch 4.
switch 1 to advance to the
switch 4.
When "1" is selected, the one-
shot automatic stitching display
lights up when the mode is
returned to the normal one.
switch 1 to advance to the
switch 4.
When "1" is selected, the thread
trimming prohibition display lights
up when the mode is returned to
the normal one.