Remote Controls; Icons Of The Remote Control; Arming Procedure - Pandora DXL 1090L User Manual

R E M O T E C O N T R O L

ICONS OF THE REMOTE CONTROL

Flashing when
command sending
Security mode
status
Remote control
battery level
12 48
Numeric indicator
displays current
time
12.0V
Battery voltage
12°
Interior
temperature
0°
Engine
temperature*
0
Fuel level*
12
PANDORA DXL 1090L SERVICE-SECURITY SYSTEM
Alarm clock
Shock sensor
security zone
Warning level of
the sensor;
Alarm level
of the sensor
Tilt sensor
Security zone
Motion sensor
security zone
Doors security
zone
Front hood
security zone
Trunk
Security zone
Ignition
Security zone
R E M O T E C O N T R O L
Handbrake/ neutral
P
indicator, Brake
pedal security zone
Low voltage
security zone
* Separate display indication of doors, original alarm status, fuel level depend on information in CAN-bus
digital protocol of specific car

ARMING PROCEDURE

Arming the system allows monitoring of all security zones, locks the doors and blocks
the engine.
To arm the system when the engine is stopped, shortly press
remote control. The siren will emit one sound signal and turn signals will flash once.
«ARMING»
The remote control will play
lock) will change to
short press doors locking
press
system arming
and hold
for 1 sec.
For arming without sound confirmation press
If when arming doors, hood or trunk were open, the siren will sound 4 short signals
instead of 1, turn signals will flash 4 times, remote will play «WARNING!» ringtone (after
«ARMING» ringtone) and will show troubled zone. This zone sensor will be disabled at
that moment. Sensor will be armed again in 15 seconds after the zone was set right.
USER MANUAL
Engine operation
icon
Engine is stopped
STOP
button on the
ringtone and security mode status icon (the
1x
1 ash
~~
1 ash
for more than 1 second.
13