Pandora DXL 1090L User Manual page 25

I M M O B I L I Z E R
engine blocking will be lifted or a programmed timer channel will be activated or the
system will be disarmed
REPLACING IMMOBILIZER TAG BATTARY
Carefully open the cover of the tag's battery
compartment. Extract discharged battery
and insert a new one keeping in mind the
correct polarity. Replacing a battery will
not cause a loss of tag code information,
as authorization data is stored in the non-
volatile memory of the MCU.
Carefully close the cover of the tag's
battery compartment. All elements of
construction should be rigidly locked in places. If it is so, the tag can be operated
as usually.
PANDORA BT APPLICATION
PANDORA BT
application is an additional tool for controlling and managing the
system state. The system can connect only to the mobile device that was previously
registered in the system memory. Registration is performed via encrypted 2.4 GHz
channel using Bluetooth Low Energy protocol. Pandora BT is available on Google Play for
devices with Android 4.4 or higher and with Bluetooth 4.0 Low Energy or higher module.
WARNING! Enable Bluetooth function on your mobile device to use
Pandora BT application.
48
PANDORA DXL 1090L SERVICE-SECURITY SYSTEM
Open here
P R O G R A M M I N G T H E S Y S T E M
Installing the application
You can download Pandora BT application from an app store (Google Play for
Android or AppStore for iOs).
After installing the application, perform the mobile device registration procedure
«REGISTRATION AND DELETING A MOBILE DEVICE»
(see p. 66)
The application usage
The system should be in the Bluetooth radio coverage zone. Start Pandora BT, the
application will automatically find the system and make a connection; after that the
main menu of the application will open.
«CONTROL»
The main menu displays the current status of the system and allows
you to control the system using multifunction buttons. Control buttons is used for
controlling the car and quick access to the system functions. The functions can be
switched on or off or the car can be remotely controlled by pressing and holding
any button until the progress bar will fully loaded (3 seconds), this is done to protect
against accidental button press. You can change button location and select the
«CONTROL BUTTONS»
desired functional in the
PROGRAMMING THE SYSTEM
ENTERING PROGRAMMING MENU
To change the system settings or program the system using a computer or
button, the system should be in programming mode. Enter programming mode by
entering the «Service PIN-code» (factory preset is 1-1-1-1). PIN-code should be entered
using external or located on the base unit
flashes of external or located on the base unit
only if the base unit is powered form USB socket or from external power supply, the
ignition is switched off, the system is disarmed and maintenance mode is switched off.
If there is no «Service PIN-code», you can enter programming mode using the
«Secret PIN-code» written on the owner's card.
USER MANUAL
).
settings.
VALET
VALET
button. The input is indicated by
LED
indicator. You can enter the code
49