Using Compuserve - IBM International ISDN User Manual

Using CompuServe

11.3 Using CompuServe
In order to be able to use CompuServe with your IBM Inter-
national ISDN PC Card, you must have cFos installed, unless
you only plan to use CompuServe 2000 on your system. In
this case, you may not need to install cFos at all.
Please ask your local CompuServe help desk what communi-
cation protocol is used for dial-in. In Europe the X.75 proto-
col is widely used.
IBM has tested the CompuServe 3.0 and higher access soft-
ware under Windows 95, 98 and ME, and CompuServe 4.0.x
and higher access software under Windows NT 4.0 and Win-
dows 2000 Professional.
11.3.1 CompuServe 3.0 and non-CAPI 2.0-compliant
CompuServe Dialers in Windows 9x, Me
Note: The screen shots in this section may vary somewhat
from the user interface you see on your screen.
Before you can use CompuServe 3.0 or any non-CAPI 2.0-
compliant CompuServe access software, you must configure
cFos for use with it by installing either the "cFos ISDN, X.75,
Defaults, Mailbox Settings" or the "cFos ISDN, CompuServe"
modem emulation on any available COM port.
When you perform a fresh installation of the CompuServe
3.0 or a non-CAPI 2.0-compliant CompuServe access soft-
ware, you may be offered the option of entering or modifying
the telephone number and modem properties.
ISDN PC Card – 11 Implementations of the IBM International ISDN PC Card 127