Binding; Transmitter Programming Setup 5P - GRAUPNER mz-24 HoTT Operating Instruction

7. BINDING

1. You must bind the receiver to the transmitter before the receiver will operate. Binding
teaches the receiver the specific code of the transmitter so that it will only connect to it's
corresponding transmitter. If you turn on transmitter's power before binding, the warning
message appears on transmitter LCD page, which announce transmitter is not bound. Touch
SET icon on warning pop up to access to Tx ctl (BIND)
Touch
2. After accessing to Tx ctl(BIND), Turn on receiver's power and touch Bind button on receiv-
er for over 3 sec to enter binding mode. Touch OFF icon in the cross line of BIND ON/OFF
and RX1 then OFFs in the cross line of BIND ON/OFF and RX1, RF ON/OFF and RX1 are
changed to ONs indicating the system has been connected. If the binding process has failed,
repeat the whole procedure.
Touch
CAUTION
We strongly recommend to unlock the throttle limit function when you control Helicopter.
Throttle limit function restrict the travel amount of throttle with DV1 volume and this function
is set by default.Touch "BASE" icon at the main page to call "BASE" page and touch "CH
set" icon to call "CH set" setup page. Touch DV1 in channel 12 to call "Select" message
popup and touch CLR in popup then DV1 is switched to NONE. Now, throttle limit function is
unlocked.
8. TRANSMITTER PROGRAMMING SETUP
BASE MENU
Turn on transmitter's power and touch B icon on the main page to access to BASE menu.
Touch
5