Programming The Regulation; Gyro Setting Display - GRAUPNER Falcon 12 Manual

Programming the regulation

Gyro setting display

GYRO SETTINGS< >
MODE AIL/ELE (2)CH7
MODE RUDD (2)CH7
>Aileron:
>Elevator:
Rudder :
Factor : (44%)C10
16 / 36
Note
Before you start entering settings for a new model, it is essential to
select the number of aileron servos in the Aileron servos menu
point, and to define the gyro axes and orientation in the New set-
tings menu point.
MODE
In this point you can select the gyro correction mode (0-3):
0 - no gyro correction
0
1 - normal gyro correction (P and D parameter)
0
2 - heading lock mode (I parameter) with suppression
0
(Outside the suppression area the gyro control is active, in stick
center position acts the heading lock)
3 - Rate mode
(Heading lock acts in stick center position through the entire area)
Note
In Heading lock mode the servos are moved to the center position
if the factor is set to 0%.
Mode switching
The mode can be set separately for AILE/ELEV and RUDD. The mode
can be set permanently or it can be switched through an assigned
channel. Program the selected channel in your transmitter with a
switch, the following positions switch the related mode:
Mode 0
Mode 1
Mode 2
Mode 3
Preparation step by step:
1. Trim the model with the gyro correction off
2. Switch the receiver off and on to save the values as standard
3. Activate the gyro correction
The phase trim should not be used!
4.
5. Set the factor for gyro correction, eventually check the values for
the single control surfaces
- 100%
- 50%
0%
≥ 50%
S1035_Falcon_12_jh_V1