Part Names; Install - Integra DRX-7.1 Basic Manual

> Before Start > Part Names

Part Names

Part Names

  
Front Panel
1. Í On/Standby button
2. Hybrid Standby indicator: Lights if the unit enters standby mode when the features are
enabled that continue to work when this unit is in standby, such as HDMI Standby
Through and Network Standby.
3. HDMI Out button: Allows you to select the HDMI OUT jack to output video signals from
"MAIN", "SUB", and "MAIN+SUB".
4. Remote control sensor: Receives signals from the remote controller.
0 The signal range of the remote controller is within about 16y/5 m, at an angle of 20° on
the perpendicular axis and 30° to either side.
5. You can adjust the sound quality of the all channels except the subwoofer. Press Tone to
> Install > Initial Setup
     

> Playback
      
 
select the desired setting from "Bass" and "Treble", and adjust with + and –.
6. Display (P4)
7. Listening Mode button: Press the Listening Mode button (above) repeatedly to select a
category from "Movie/TV", "Music", "Game", then turn the Listening Mode dial (below) to
change the mode (P34). (*)
8. Dimmer button: You can adjust the brightness of the display in three steps. It cannot be
turned off completely.
9. Memory button: Used to register AM/FM radio stations (P31).
10.Tuning Mode button: Switches the tuning mode (P30).
11. Info button: Switches the information on the display (P34).
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
(*)You can find details in the Advanced Manual.

3
En