Integra DRX-7.1 Basic Manual page 4

> Before Start > Part Names
12.Setup button: You can show advanced setting items on the TV and display to provide you
with an even better experience. (*)
13.Cursor buttons ( /  /  / ) and Enter button: Select the item with the cursors and
press Enter to confirm. Use them to tune to stations when using Tuner.
14.Return button: Returns the display to the previous state.
15.Master Volume
16.Zone 2/Zone 3 button: Controls the multi-zone function. (P32)
Off button: Switches the multi-zone function off.
17.Whole House Mode button: Enables the WHOLE HOUSE MODE function to play the
same source in all the multi-zone connected rooms. (P33)
Off button: Switches the WHOLE HOUSE MODE function off.
18.Phones jack: Headphones with a standard plug (Ø1/4z/6.3 mm) are connected.
19.Setup Mic jack: The supplied speaker setup microphone is connected.
20.Input selector buttons: Switches the input to be played.
21.AUX Input HDMI jack: Connect a video camera, etc., using a HDMI cable.
4
> Install > Initial Setup > Playback
  

Display
1. Speaker/Channel display: Displays the output channel that corresponds to the selected
listening mode.
2. Lights in the following conditions.
Ë: When headphones are connected.
Z2/Z3: When ZONE 2/ZONE 3 is on.
NET: When "NET" is selected with the input selector and the unit is connected to the
network. It will flash if the connection to the network is not correct.
USB: When "NET" is selected with the input selector and the unit is connected by USB
and the USB device is selected. Flashes if the USB is not properly connected.
HDMI: When HDMI signals are input and the HDMI input is selected.
DIGITAL: When digital signals are input and the digital input is selected.
3. Lights according to the type of input digital audio signals and the listening mode.
4. Lights in the following conditions.
RDS (Australian models): Receiving RDS broadcasting.
TUNED: Receiving AM/FM radio.
FM ST: Receiving FM stereo.
SLEEP: When the sleep timer is set. (*)
AUTO STBY: Auto Standby is on. (*)
5. Flashes when muting is on.
6. Displays various information of the input signals. Characters that cannot be displayed on
this unit are replaced with asterisks (¢).
0 When playing back software which has been encoded in Dolby Digital, Dolby Digital
Plus, Dolby TrueHD and Dolby Atmos, sometimes you may see a brief message which
will read "DialogNorm: X dB" (X being a numeric value). For example, if you see the
following message: "DialogNorm:+4dB", to keep the overall output level at THX
calibrated loudness, just turn down the volume control by 4dB.
7. This may light when performing operations with the "NET" input selector.
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
(*)You can find details in the Advanced Manual.
 
 