Integra DRX-7.1 Basic Manual page 13

> Before Start > Part Names
Speaker combinations
0 In any of the combinations, up to two powered subwoofers can be connected.
Speaker
Channels FRONT
2.1 ch
3.1 ch
4.1 ch
5.1 ch
6.1 ch
7.1 ch
2.1.2 ch
3.1.2 ch
4.1.2 ch
5.1.2 ch
6.1.2 ch
7.1.2 ch
4.1.4 ch
5.1.4 ch
6.1.4 ch
7.1.4 ch
Points to note with speaker combinations
(*1) It is not possible to use Bi-AMP and ZONE speakers at the same time. However, with 2.1 ch to 7.1
ch, it is possible to use Bi-AMP and ZONE 2 speakers at the same time.
(*2) If you have not connected ZONE 3 speakers in another room but have only connected ZONE 2
speakers, connect the ZONE 2 speakers to the HEIGHT 1 jacks. However, if Bi-Amping connections
are used for front speakers, connect the ZONE 2 speakers to the HEIGHT 2 jacks.
(*3) If front speakers are to be Bi-Amping connected, height speakers need to be connected to the
HEIGHT 2 jacks.
(*4) ZONE 2 speakers need to be connected to the HEIGHT 1 jack, ZONE 3 speakers need to be connected to
the SURROUND BACK jacks, and height speakers need to be connected to the HEIGHT 2 jacks.
(*5) This unit consists of a 9 ch amplifier, so when using a Bi-Amping connection for the front speakers,
use an analog audio cable to connect the power amplifier to the PRE OUT HEIGHT 2 jacks, then
connect the height speakers to the power amplifier.
(*6) This unit consists of a 9 ch amplifier, so with this combination use an analog audio cable to connect
> Install > Initial Setup
SURROUND
CENTER SURROUND
> Playback
BACK HEIGHT 1 HEIGHT 2
(*3)
(*3)
(*3)
(*3)
(*5)
(*5)
(*6)
(*6)
the power amplifier to the PRE OUT BACK jacks, then connect the surround back speakers to the
power amplifier.
HEIGHT 1/HEIGHT 2
When connecting 2 sets of height speakers, the height speaker combinations you can choose are as
follows.
– Height 1 Speaker: Top Middle, Height 2 Speaker: Rear High
– Height 1 Speaker: Front High, Height 2 Speaker: One of Rear High/Top Middle/Top Rear/Dolby
Enabled Speaker (Surround)/Dolby Enabled Speaker (Surround Back)
– Height 1 Speaker: Top Front or Dolby Enabled Speaker (Front), Height 2 Speaker: One of Rear High/
Top Rear/Dolby Enabled Speaker (Surround)/Dolby Enabled Speaker (Surround Back)
When connecting only one set of height speakers, select one type of height speakers from the types
available.
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
ZONE 2 (*1) ZONE 3 (*1)
(ZONE SPEAKER) (ZONE SPEAKER)
Bi-AMP (*1) (P22)
(*2)
(*2)
(P23)
(*4)
(*4)
(*4)
(*4)
13
En