Initial Setup With Auto Start-Up Wizard - Integra DRX-7.1 Basic Manual

> Before Start > Part Names

Initial Setup with Auto Start-up Wizard

Initial Setup
1
INPUT
2
> Install
3
> Initial Setup > Playback > Advanced Manual
Troubleshooting | Supplementary Information, etc.
Initial Setup Starts Automatically
When you turn the unit on for the first time after purchasing
it, Initial Setup is automatically shown on the TV to enable
you to make settings required for startup using simple
operations following onscreen guidance.
1. Switch the input on the TV to that assigned to the unit.
2. Put batteries into the remote controller of this unit.
3. Press Í on the remote controller to turn the unit on.
4. Select the item with the cursors of the remote controller
and press Enter (a) to confirm your selection. To return to
the previous screen, press (b).
a
0 If you terminate the procedure on the way or want to
change a setting made during Initial Setup, press
the remote controller, select "8. Miscellaneous" – "Initial
Setup", and press Enter.
0 A confirmation screen asking you to agree to the privacy
policy is displayed during network setting. Select
"Accept" and press Enter to indicate agreement.
∫ 1. AccuEQ Room Calibration
Place the supplied speaker setup microphone in the
listening position, measure the test tones emitted by the
speakers, then the unit automatically sets the optimum
volume level for each speaker, the crossover frequencies,
and the distance from the listening position. This also
enables correction of distortion caused by the acoustic
b
on
25
En