Integra DRX-7.1 Basic Manual page 50

> Specifications > Advanced Setup
Setting Item Default Value
Height 2 80Hz (THX)
Surround 80Hz(THX)
Surround Back 80Hz(THX)
LPF of LFE 120Hz
14
> Listening Modes > Network Functions
Setting Details
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when
"Surround" is set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set the low-pass filter for LFE (low-frequency
effect) signals in order to pass lower frequency
signals than the set value and thus cancel
unwanted noises. The low-pass filter will be
effective only on sources with LFE channel.
The value from "80Hz" to "120Hz" can be set.
"Off": When this function is not to be used
Setting Item Default Value
Double Bass On
■ 3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value
Front Left 12' 0" / 3.60 m
Center 12' 0" / 3.60 m
Front Right 12' 0" / 3.60 m
Height 1 Left 9' 0" / 2.70 m
Height 1 Right 9' 0" / 2.70 m
Height 2 Left 9' 0" / 2.70 m
> Basic Manual
Troubleshooting | Supplementary Information, etc.
Setting Details
This can be selected only when "Configuration" -
"Subwoofer" is set to other than "No" and "Front" is
set to "Full Band".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
• The setting will not automatically be configured
even if you performed AccuEQ Room
Calibration.
Setting Details
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Specify the distance between each speaker and
the listening position.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Specify the distance between each speaker and
the listening position.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.