Others; Part Names - Integra DRX-2 Basic Manual

> Before start > Hookup

Others

Listening To the Radio
a
1. Press Tuner (a) on the remote controller repeatedly to
select either "AM" or "FM" on the display.
2. Press Mode (c) on the remote controller, so that the
"TunMode: Auto" is displayed on the display.
b
3. When you press the
remote controller, automatic tuning starts, and searching
stops when a station is found. When tuned into a radio
station, the "TUNED" indicator on the display lights.
You can preset up to 40 stations.
1. Tune into the AM/FM radio station you want to register.
2. Press Memory (d) on the remote controller so that the
preset number on the display flashes.
3. While the preset number is flashing (about 8 seconds),
c
repeatedly press the
d remote controller to select a number between 1 and 40.
4. Press Memory (d) again on the remote controller to
e
register the station. When registered, the preset number
stops flashing. To select a preset radio station, press the
/
0 To delete a preset station, press the
buttons on the remote controller to select the preset
number you want to delete, press Memory (d) on the
remote controller and then press Clear (e) while the
preset number is flashing. When deleted, the number on
the display goes off.
Frequency step setting
Press the
Miscellaneous" – "Tuner" – "AM/FM Frequency Step" or
"AM Frequency Step" and select the frequency step for
your area. Note that when this setting is changed, all radio
presets are deleted.
> Setup
/ cursor (b) buttons on the
/ cursor (b) buttons on the
cursor (b) buttons on the remote controller.
/ cursor (b)
button on the remote controller to select "8.
> Playback > Part Names
d
e
b
c
a
Multi-zone
If you haven't made the Multi Zone settings in Initial Setup
( P19), change the settings according to the audio output
method to the separate room (ZONE 2). If you have
connected speakers in a separate room with speaker
cable, press the button on the remote control, then
select "Zone 2" in "2. Speaker" - "Configuration" - "Zone
Speaker". If you have connected a power amplifier in a
separate room with an analog audio cable, then set "7.
Multi Zone" - "Zone 2" - "Output Level" to "Variable" if you
want to be able to adjust the volume on this unit.
Play
1. While holding down Mode (a) on the remote controller,
press Zone 2 (b) for 3 or more seconds until the remote
indicator blinks twice.
0 The remote controller switches to the mode for
controlling ZONE 2.
To return the remote controller to main room control
mode: While holding down Mode (a) on the remote
controller, press Main (c) for 3 seconds or more until the
remote indicator flashes once.
2. Point the remote controller at the main unit and press Í
(d).
"Z2" lights on the main unit display.
3. Press the input selector button (e) of the input to be
played in the separate room. To control on the main unit,
press Zone 2 and within 8 seconds, press the input
selector button of the input to be played in a separate
room. To play the same source in the main room and
separate room, press Zone 2 on the main unit twice.
0 You cannot select different inputs for the main room
and separate room with the "NET" or "BLUETOOTH"
input selector. You cannot select different stations for
23