Integra DRX-7.1 Basic Manual page 49

> Specifications > Advanced Setup
Setting Item Default Value
Bi-Amp No
> Listening Modes > Network Functions
Setting Details
Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• In any of the following cases, this item will be
set to "No":
– When two sets of height speakers are being
used
– When "Zone Speaker" is set to "Zone 2/Zone
3"
– When height speakers and ZONE speakers
are being used at the same time
■ 2. Crossover
• If you are using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz" in "LPF of LFE".
– Set a value "Off" in "Double Bass".
Setting Item Default Value
Front 80Hz(THX)
Center 80Hz(THX)
Height 1 80Hz (THX)
> Basic Manual
Troubleshooting | Supplementary Information, etc.
Setting Details
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be
output from the front speakers. Refer to the
instruction manual of your speakers to make the
setting.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
13