Integra DRX-7.1 Basic Manual page 55

> Specifications > Advanced Setup
■ 2. Dolby
Setting Item Default Value
Loudness On
Management
■ 3. DTS
Setting Item Default Value
DTS Auto On
Surround
■ 4. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel
PCM, and DSD signals.
Setting Item Default Value
LFE Level 0dB
> Listening Modes > Network Functions
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is to be used
"Off": When this function is not to be used
Setting Details
When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker configuration of this unit when playing in
the straight decoding listening mode.
"On": Use this function
"Off": Audio is played using the same amount
of channels in the input signal according to the
speaker configuration of this unit.
• The ES Matrix and ES Discrete listening modes
cannot be selected if this function is set to "Off".
Setting Details
Select the low-frequency effect (LFE) level of each
type of signal from "0dB" to "− dB". If the low-
frequency effect sound is too strong, select
"−20dB" or "− dB".
■ 5. Volume
Setting Item Default Value
Volume Display Absolute
− dB
Mute Level
Maximum Volume Off
Power On Volume Last
Headphone Level 0.0 dB
> Basic Manual
Troubleshooting | Supplementary Information, etc.
Setting Details
Switch the volume display between the absolute
value and relative value. The absolute value 82.0 is
equivalent to the relative value 0.0dB.
"Absolute": Absolute value such as "0.5" and "99.5"
"Relative": Relative value such as "-81.5dB" and
"+18.0dB"
• If the absolute value is set to 82.0, "82.0Ref" will
appear on the display.
Set the volume lowered from the listening volume
when muting is on. Select a value from "− dB",
"−40dB", and "−20dB".
Set the maximum value to avoid too high volume.
Select a value from "Off", "50" to "99". (When
"Volume Display" is set to "Absolute")
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "Min", "0.5" to "99.5"
and "Max". (When "Volume Display" is set to
"Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Adjust the output level of the headphones. Select a
value between "−12.0 dB" and "＋12.0 dB".
19