Step7: Power On & Initial Setup - Integra DRX-7 Basic Manual

> Before start > Hookup
Step7: Power On & Initial Setup
Initial Setup starts automatically
Switch the input on the TV to that assigned to the unit.
When you turn the unit on for the first time, Initial Setup is
automatically shown on the TV to enable you to make
settings required for startup using simple operations
following onscreen guidance.
0 If you terminate the procedure on the way or want to
change a setting made during Initial Setup, press
the remote controller, select "8. Miscellaneous" – "Initial
Setup", and press Enter.
> Setup > Playback
on
> Part Names
1. AccuEQ Room Calibration
Place the supplied speaker setup microphone in the
listening position, measure the test tones emitted by the
speakers, then the unit automatically sets the optimum
volume level for each speaker, the crossover frequencies,
and the distance from the listening position. This also
enables correction of distortion caused by the acoustic
environment of the room.
Setup Mic
0 When putting the speaker setup microphone on a tripod,
refer to the illustration when putting it in place.
: Selection
0 Set the subwoofer volume to more than halfway.
0 Calibration takes between 3 and 12 minutes to be
completed. The speakers emit the test tone at high
: OK
volume during measurement, so be careful of your
surroundings. Keep the room as quiet as possible during
: Return
measurement.
0 When using THX certified speakers, THX recommends
setting the crossover frequency to "80Hz(THX)". It is also
recommended to manually adjust the settings for each
speaker to suit the specific characteristics of each room.
0 If the power of this unit suddenly turns off, the wires in
the speaker cables may have touch the rear panel or
other wires and tripped the protection circuit. Twist the
wires again properly and make sure they do not stick out
of the speaker terminals when connecting.
21