Chapter 6 Wiring - Mitsubishi Electric RJ72GF15-T2 User Manual

6
WIRING
This chapter describes the wiring to the remote head module.
Wiring methods
The following describes connection and disconnection of the Ethernet cable. For cables and switching hubs required for
wiring, refer to the following.
 User's manual for the master/local module used
■Connecting the cable
1.
Push the Ethernet cable connector into the remote head module until it clicks. Pay attention to the connector's direction.
2.
Lightly pull it to check that it is securely connected.
3.
Check whether the LINK LED of the port connected with an Ethernet cable is on.
*1 The time between the cable connection and the LINK LED turning on may vary. The LINK LED usually turns on in a few seconds. Note,
however, that the time may be extended further if the link-up processing is repeated depending on the status of the device on the line. If
the LINK LED does not turn on, refer to the following and take corrective actions.
 MELSEC iQ-R CC-Link IE Field Network Remote Head Module User's Manual (Application)
Both P1 connector and P2 connector can be used.
• When only one connector is used in star topology, either P1 connector or P2 connector is applicable.
• When two connectors are used in line topology and ring topology, the cable can be connected between P1
and P1, P2 and P2, or between P1 and P2 as shown below.
■Disconnecting the cable
1.
Press the latch down and unplug the Ethernet cable.
*1
6 WIRING
6
31