FUEL INJECTION (FUEL SYSTEMS)
5. Crankshaft Position Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bolt which installs the crankshaft
position sensor to cylinder block.
3) Remove the crankshaft position sensor, and
then disconnect the connector from it.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
For tightening torque, refer to "COMPONENT".
<Ref. to FU(H4SO)-3, COMPONENT, General De-
scription.>
Crankshaft Position Sensor
FU-00009
FU-00056
FU-00057
FU(H4SO)-28