Subaru IMPREZA 2004 Service Manual page 169

B: INSTALLATION
(1)
(1) Crankshaft bearing
(2) Crankshaft
NOTE:
Remove oil in the mating surface of bearing and
cylinder block before installation. Also apply a coat
of engine oil to crankshaft pins.
1) Position the crankshaft on #2 and #4 cylinder
block.
2) Apply fluid packing to the mating surface of #1
and #3 cylinder block, and position it on #2 and #4
cylinder block.
Fluid packing:
Part No. 004403007
THREE BOND 1215 or equivalent
Cylinder Block
(4)
(3)
(3) Cylinder block
NOTE:
Do not allow fluid packing to jut into O-ring grooves,
oil passages, bearing grooves, etc.
3) Tighten the 10 mm cylinder block connecting
bolts in alphabetical sequence shown in the figure.
(LH side)
ME(H4SO)-73
(3)
(2)
(4) Rear oil seal
MECHANICAL
ME-00144
ME-00145