Subaru IMPREZA 2004 Service Manual page 34

FUEL INJECTION (FUEL SYSTEMS)
4) When using Subaru Select Monitor;
(1) Turn the ignition switch to OFF.
(2) Loosen the throttle position sensor holding
screws.
NOTE:
For detailed operation procedures, refer to the Sub-
aru Select Monitor Operation Manual.
(3) Insert the cartridge to the Subaru Select
Monitor.
(4) Connect the Subaru Select Monitor to the
data link connector.
5) Turn the ignition switch to ON, and the Subaru
Select Monitor switch to ON.
6) Select the {2. Each System Check} in «Main
Menu».
7) Select the {Engine Control System} in «Selec-
tion Menu».
8) Select the {1. Current Data Display & Save} in
«Engine Control System Diagnosis».
9) Select the {1.12 Data Display} in «Data Display
Menu».
Throttle Position Sensor
10) Adjust the throttle position sensor to the proper
position to match with following specifications.
Condition: Throttle fully closed
11) Tighten the throttle position sensor holding
screws.
Tightening torque:
FU-00291
ST
FU-00293
ME-00325
FU(H4SO)-32
Throttle opening angle 0.00%
Throttle sensor voltage 0.50 V
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
FU-00291