Subaru IMPREZA 2004 Service Manual page 716

ENGINE (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the SUBARU Select Monitor kit.
2) Connect the diagnosis cable to SUBARU Select
Monitor.
3) Insert the cartridge into SUBARU Select Moni-
tor.
4) Connect the SUBARU Select Monitor to data link
connector.
(1) The data link connector is located in lower
portion of instrument panel (on driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools except for SUB-
ARU Select Monitor.
Subaru Select Monitor
5) Turn the ignition switch to ON (engine OFF) and
SUBARU Select Monitor switch to ON.
6) Using the SUBARU Select Monitor, call up any
DTCs and various data, then record them.
EN-00038
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE.
Refer to Read DTC for information about how to in-
dicate the DTC. <Ref. to EN(H4SOw/oOBD)(diag)-
24, Read Diagnostic Trouble Code (DTC).>
EN-00039
EN-01287
EN(H4SOw/oOBD)(diag)-20
(A) Power switch
(A)
EN-00040