Subaru IMPREZA 2004 Service Manual page 606

(3) Insert the cartridge to Subaru Select Moni-
tor.
(4) Connect the Subaru Select Monitor to data
link connector.
5) Turn the ignition switch to ON, and Subaru Se-
lect Monitor switch to ON.
6) Select the {2. Each System Check} in Main
Menu.
7) Select the {Engine Control System} in Selection
Menu.
8) Select the {1. Current Data Display & Save} in
Engine Control System Diagnosis.
9) Select the {1.12 Data Display} in Data Display
Menu.
10) Adjust the throttle position sensor to proper po-
sition to match with the following specifications.
Condition: Throttle fully closed
Throttle opening angle 0.00%
Throttle sensor voltage 0.50 V
11) Tighten the throttle position sensor holding
screws.
NOTE:
For tightening torque, refer to "COMPONENT".
<Ref. to FU(H4SOw/oOBD)-3, COMPONENT,
General Description.>
Throttle Position Sensor
ST
FU-00293
FU-00933
FU(H4SOw/oOBD)-33
FUEL INJECTION (FUEL SYSTEMS)