Subaru IMPREZA 2004 Service Manual page 293

NOTE:
Note the direction of the lever before removing.
(A)
(A) Shaft ASSY
(B) Overrunning clutch
(C) Lever
7) Remove the overrunning clutch from shaft as-
sembly as follows:
(1) Remove the stopper from ring by lightly tap-
ping the stopper with an appropriate tool (such
as a fit socket wrench).
(2) Remove the ring, stopper and clutch from
shaft.
(A) Socket wrench
(B) Ring
(C) Shaft
(D) Stopper
(C)
(B)
SC-00173
SC-00014
SC(H4SO)-9
Starter
2. BRUSH HOLDER
NOTE:
Only the brush holder of turbo MT model starter
can be disassembled.
Slightly open the metal fitting while holding the in-
sulating plate against the brush holder. Remove
the insulating plate.
The brush and spring can be easily removed from
the brush holder at this time.
(A) Brush holder
(B) Insulating plate
(C) Metal fitting
D: ASSEMBLY
1) Assemble in the reverse order of disassembly.
2) Apply grease to the following parts before as-
sembly.
• Front and rear bracket sleeve bearings
• Armature shaft gear
• Outer periphery of plunger
• Mating surfaces of plunger and lever
• Gear shaft splines
• Mating surfaces of lever and clutch
• Ball at armature shaft end
• Planetary gear
E: INSPECTION
1. ARMATURE
1) Check the commutator for any sign of burns of
rough surfaces or stepped wear. If wear is of a mi-
nor nature, correct it by using sand paper.
2) Run-out test
Check the commutator run-out, and then replace if
it exceeds the limit.
STARTING/CHARGING SYSTEMS
(B)
(C)
SC-00174
(A)