Operation - Upright SB-80 Operator's Manual

19 20 21 22
23 24
25
17
18
33
31
29 30 32
28
Figure 1: Platform Controls
17. Axle Extend/Retract 27. Auxiliary power (for
emergency lowering
18. Lights (optional)
only)
19. Generator (optional)
28. Boom Raise/Lower &
20. Horn Button
Turret Rotate control
21. Emergency Stop
29. Boom Extend/Retract
22. Axles Extended indicator
30. Cage Rotate
23. Tilt warning indicator
31. Jib Raise/Lower
24. Low oil pressure indica-
32. Cage Level
tor
33. Drive control handle/
25. Torque/Speed selector
interlock
26. Fuel selector (Gas only)/
34. Engine start
Glow plug (Diesle only)
35. Foot interlock switch
O
PERATION
Before operating work platform ensure that:
Pre-operation and safety inspection has been
completed, and any discrepancies have been
corrected.
System function inspection has been performed.
Operator has been thoroughly trained on the
operation of the machine.
Work area is clear of all obstructions, holes, drop-
offs, or persons in the route of travel.
Surface is capable of supporting wheel loads.
Refer to figures 1 through 5 for control locations.
Emergency Stop
At any time during operation, press the emergency
stop button to stop all functions in the event of an
emergency.
Service Horn
27
At any time during operation, press the service horn
26
button to sound an audible warning in necessary.
:$51,1*

ALWAYS wear an approved fall restraint
properly attached to designated platform
anchorage point when driving or operating the
machine (See figure 6).
Attach only one restraint to each anchorage
point.
Figure 2: Typical Fall Restraint Anchorage Point
Starting the Engine
From the Lower Controls
1. Turn the chassis key switch to chassis position.
2. Press the start button to crank the engine. Release
when the engine starts.
3. Diesel Engines: When the engine is cold (less than
15°f); press and hold the glow plug button for 20 sec-
onds prior to starting.
From the platform controls
1. Turn the chassis key switch to platform controls.
2. Turn the platform rotary switch fully clockwise to crank
the engine. Release when engine starts.
3. Diesel Engines: When the engine is cold (less than
15°f); press and hold the glow plug button for 20 sec-
onds prior to starting.
4
N :
OTES

13