Table of Contents
Advertisement
SB-80 Label Identification: All of the labels shown in Figure 13 shall be present and in good condition
before operating the work platform. Be sure to read, understand and follow these labels when operating
the work platform.
Figure 13: Label Identification
10
E
O
MERGENCY
PERATION
In the event of an engine failure, the elevating
assembly may be lowered using the following proce-
dure
:$51,1*
NEVER climb down the elevating assembly. If
controls do not respond, follow the emergency
lowering procedure.
Lowering Elevating Assembly
1. Engage the auxiliary power unit switch.
2. Operate any boom function in the normal manner.
Note: Auxiliary battery is capable of one
emergency lowering cycle before requiring
recharge. Battery is recharged while engine
is in operation.
EMERGENCY TOWING
&$87,21
DO NOT tow the machine faster than 3 mph.
Faster speeds will damage drive components
and void warranty.
:$51,1*
There are no brakes when the center caps are
installed in the inverted position.
Perform the following only when the machine will not
operate under its own power and it is necessary to
move the machine or when winching onto a trailer
for transportation.
1. Ensure that the platform is fully lowered, and that the
turret is rotated so that the platform is to the rear of the
machine.
:$51,1*
Chock wheels before disengaging hubs.
Machine may roll.
2. Refer to figure 7 and disengage all four drive hubs.
Remove two (2) screws and center cap. Reinstall center
cap in the opposite direction.
3. When ready to move the machine, remove the chocks.
Tow or winch into position and replace chocks.
4. Attach adequate chain/cable of sufficient strength for
towing the machine to the front or rear tie down lugs.
5. Engage all four drive hubs by returning the center caps
to their original orientation.
Drive Hub
Center Cap
Screws
Figure 1: Drive Hub (Operating position shown)
Switching Fuels (Gas/Propane Only)
1. With the engine running push the Fuel Selector Switch
to the center position.
2. After the engine has quit running select the appropriate
fuel supply.
3. Restart the engine.
A
U
E
D
FTER
SE
ACH
AY
1. Ensure that the platform is fully lowered.
2. Park the machine on level ground, preferably under
cover, secure against vandals, children or unauthorized
operation.
3. Turn the key switch to OFF and remove the key to pre-
vent unauthorized operation.
M
E
W
P
ACHINES
QUIPPED
ITH
LUS
O
PTION
Machines equipped with Plus3 option are capable of
operating all functions on a firm 3° slope.
:$51,1*
Do not operate machines with Plus3 option
unless machine is equipped with foam filled
tires. Remove machine from service and install
proper tire/wheel combination before operating
machine.
:$51,1*
If tilt warning sounds and machine will not
operate, retract boom, lower platform and move
machine to a firm surface less than 3°.
7
3
Advertisement
Table of Contents
