Pre-Operation Safety Inspection - Upright SL26SL Service Manual

Pre-Operation Safety Inspection

P -O
RE PERATION
NOTE: Carefully read, understand and follow all safety rules, operating instructions, labels and
National Safety Instructions/Requirements. Perform the following steps each day before use.
1. Open modules and inspect for damage, fluid leaks or missing parts.
2. Check the level of the hydraulic fluid with
the platform fully lowered. The hydraulic
reservoir is located in the Control Mod-
ule Door. The fluid level must be
between the MIN and MAX lines. Add
hydraulic fluid if necessary.
3. Check that fluid level in the starter bat-
tery is correct.
4. Check the level of the Diesel fuel with
the engine switched off. The fuel tank is
located in the Power Module. Add fuel
as required.
5. Check that all guardrails are in place
and all fasteners are properly tightened.
6. Inspect the machine thoroughly for
cracked welds and structural damage,
loose or missing hardware, hydraulic
leaks, damaged control cable, loose wire connections and wheel bolts.
Page 6
S I
AFETY NSPECTION
Operation Manual
Figure 3: Hydraulic Tank