Safekeeping And Storage; Storage; Facepiece - MSA G1 SCBA Operating Manual

20

Safekeeping and Storage

20.1 Storage

WARNING!
Verify that the alkaline battery module has new batteries and that the rechargeable battery module
is fully charged prior to storage. Verify that the control module displays a full charge battery status
icon and that the HUD does not display low battery status indicators.
DO NOT drop the cylinder or bump the valve knob. An unsecured cylinder can become an airborne
projectile under its own pressure if the valve is opened even slightly.
Misuse can result in serious injury or death.
• Do not store the SCBA or spare cylinders within or near an area where the SCBA can or might be
exposed to any substances that will or might attack any part of the SCBA, causing the SCBA to not
perform as designed and approved.
• Prior to storing the SCBA in a jumpseat, ensure there is no interference between the SCBA and
the seat. Ensure the SCBA and cylinder can be removed easily without damaging the components.
• Do not store the SCBA for extended periods with the batteries installed in the electronic compo-
nents if the SCBA is not intended for service. If the SCBA is in service, ensure that the batteries in
the electronic components have an adequate charge.
• Do not store the SCBA with an empty or partially filled cylinder. Always install a fully-charged
cylinder so that the SCBA is ready for use.
• Complete Inspection and Cleaning and Disinfecting Procedures outlined in this manual. Ensure
the entire SCBA is clean and dry.
• Ensure the facepiece head harness adjustment straps are fully extended. Place the complete
SCBA in the storage case or suitable storage location so it can be easily reached for emergency
use.
• The rechargeable battery module should be stored, fully charged, at temperatures between -4 °F
and 104 °F (-20 °C and 40 °C). It is recommended that the rechargeable battery module be
charged every six months if it has not been in use or if it has not been kept continuously in a
charger.
• For prolonged storage of the SCBA, remove alkaline batteries from all electronic components and
housings to prevent battery corrosion. Store the units in a cool, dry place.

20.2 Facepiece

For the safekeeping of the facepiece, a facepiece pouch or container should be used.
WARNING!
In order to avoid damage to or the deformation of the facepieces keep no additional loose objects in
the facepiece container. Failure to follow this warning can result in serious injury or death.
MSA rubber products are protected by an anti-ageing agent that can become visible as a light coating.
This coating is harmless and can be removed during cleaning.
To ensure a long life of rubber components, follow ISO 2230 by storing them in a cool, dry place
protected from ultraviolet radiation.
G1 SCBA
Safekeeping and Storage
US
93