Move, Copy, Or Delete A User Test; More About Autotest - Netscout OneTouch AT 10G User Manual

OneTouch AT 10G
User Manual
An asterisk is also displayed after the profile name at the top-left
corner of the HOME screen, to indicate that the test profile has
been changed. See Chapter 6: "Profiles," beginning on

Move, Copy, or Delete a User Test

Touch and hold the test's icon on the HOME screen. Four icons
appear at the bottom of the screen.
 Tap the stop button to cancel the operation.
 Tap the trash can to delete the test.
Tap the copy icon to copy the test. The copied test appears to

the right of the original test.
Tap the move icon, then tap a highlighted destination to

move the test.
If you do not tap one of the Cancel, Delete, Copy, or Move

icons, you can tap a destination on one of the three user test
tiers to move the test.

More About AutoTest

AutoTest is the automatic test feature of the OneTouch AT 10G
analyzer.
AutoTest provides a comprehensive test of network
infrastructure, followed by customizable user tests that you
define.
Network Infrastructure Tests are described on page 63.

User Tests are described on page 83.

When AutoTest runs, the HOME screen is displayed so you can
monitor the overall results. You can tap a test's icon to view its
RESULTS screen.
When AutoTest completes, the analyzer retains its wired
connections (link and IP address), and wired analysis begins.
When you run AutoTest again, the following actions occur.
60
page 139.