Configuration - Netscout OneTouch AT 10G User Manual

See "How it Works" on

Configuration

Network performance is measured between two points.
Therefore, configuration includes setting up both the source and
end-point analyzers. For this test:
 The source is the OneTouch AT 10G analyzer on which the test
is configured and controlled.
The endpoint is an OptiView XG that is appropriately

connected and configured to receive instructions from a
OneTouch AT 10G.
The OneTouch AT 10G tester initially operates as the controller,
then transfers control to the OptiView XG - the OneTouch then
operates as a Performance Peer. Note that separate upstream and
downstream measurements are shown for throughput, frames
lost, and jitter, while latency shows results based on round-trip
traffic / packets.
10G Wired Performance Test (Y.1564)
page 122 to learn more.
Chapter 5: User Tests
117