To Start The Setup Wizard At A Later Time; Registering The Onetouch At Analyzer; Connect To The Management Port; Handling Connection Problems - Netscout OneTouch AT 10G User Manual

OneTouch AT 10G
User Manual
You can exit the Setup Wizard at any time by selecting the EXIT
button

To Start the Setup Wizard at a Later Time

You can run the Setup Wizard again, at any time, to create
additional Profiles.
Tap the TOOLS icon
1
Tap the Setup Wizard button.
2
The registration and cloud service setup sections of the wizard are
not included in TOOLS
complete them once.

Registering the OneTouch AT Analyzer

Upon first power-on, the Setup Wizard guides you through the
registration process.

Connect to the Management Port

To register directly from the analyzer, you must establish a wired
Ethernet connection to the analyzer's management port. Connect
a cable from your network to the RJ-45 Ethernet connector at the
lower left side of the analyzer, next to the power connector.
After making the connection, tap the NEXT

Handling connection problems

If you get an error message stating that the OneTouch Internet
connection was not established, follow these steps to
troubleshoot the problem.
Proxy Server
If a network connection was established at the management port
but the analyzer could not reach the OneTouch AT cloud site on
the Internet, the next screen displayed will give you the
opportunity to specify a proxy server.
42
.
on the HOME screen.

Setup Wizard because you only need to
button.