Table of Contents
Advertisement
Chapter 5: User Tests
1G Wired Performance Test (RFC 2544)
SETUP Parameters
The following configuration settings are available in the SETUP
tab of the 1G Wired Performance (RFC 2544) test:
Figure 39. 1G Wired Performance Test Setup Tab
Type - specifies that the endpoint device will behave as a
performance peer or reflector.
Peer/Reflector - specifies the IP address of the endpoint device.
Name - allows you to assign a custom name to the test. See also:
"Name" on
page
84.
103
Advertisement
Table of Contents
Need help?
Do you have a question about the OneTouch AT 10G and is the answer not in the manual?
Questions and answers