Netscout OneTouch AT 10G User Manual page 139

Data Transfer is the time it took to send the email header and
payload to the target server.
Total Time is the sum of DNS lookup, TCP connect, data start, and
data transfer time. It is the total amount of time it took to send
the email from the analyzer.
Data Bytes indicates the total number of data bytes transferred.
Rate is the measured bit rate, based on frames sent and the
number of frames received.
A ping test runs simultaneously with the SMTP test. If the SMTP
test finishes before the ICMP echo reply packet arrives, dashes will
be displayed for the ping test results. Ping results do not affect
the Pass/Fail status of the test.
Return Code specifies the end-of-test status or an error condition
if encountered.
Below the Return Code, the target server addresses are displayed.
If you specified a target server's URL, these addresses were
supplied by DNS servers.
At the bottom-left corner of the screen, an icon indicates the
test's status:
A progress spinner indicates the test is in progress.
A green check mark indicates the test passed.
A red x indicates the test failed.
Tap the TEST AGAIN button
TOOLS button
launch a browser against the target server, or Telnet/SSH to the
server.
to run path analysis to the target server,
Chapter 5: User Tests
Email (SMTP) Test
to re-run the test. Tap the
137