Setting Up The Tester; Ip Configuration - Netscout LinkRunner AT 1000 User Manual

S U
VI. ETTING P THE
To change settings on the tester, select Tools from the home
screen.
Figure 4. Tools Menu
T
ESTER

IP Configuration

Select Tools > IP Configuration.
Figure 5. IP Configuration Screen
This screen allows you to enter an IPv4 address or use a
DHCP address (default). It also allows you to enable IPv6
addressing (2000 model only). LR-AT uses the IP address
during AutoTest. During AutoTest, the LR-AT is required to
connect to the network for Ping and TCP Connectivity testing.
At no other time does the LR-AT connect to the network using
IP addressing. This applies to the Switch and Cable test
screens.
12

Setting Up the Tester