Set The Operation Mode; Specify The Listening Device; Specify The Block Page Device - 8e6 Technologies R3000 User Manual

Set the Operation Mode

The default Mode setting is "Invisible". To change this
setting, click the radio button corresponding to "Router",
"Firewall", or "Mobile"—the latter if this R3000 will only be
used for filtering end users who have the 8e6 Mobile Client
installed on their workstations.
WARNING: If using the router or firewall mode, 8e6 recommends
contacting one of our solutions engineers if you need any assis-
tance with setup procedures.

Specify the Listening Device

In the Listening Device frame, select the default listening
Device for the selected mode: "LAN1" or "LAN2".
If using the invisible mode, "LAN1" displays by default. If
using the router or firewall mode, you may need to select the
network card that will be used to "listen to"—as opposed to
"send"—traffic on the network.

Specify the Block Page Device

In the Block Page Device frame, "LAN2" displays as the
default device for sending block pages to client PCs in the
invisible mode.
TIP: For the invisible mode, the block page device should be a
different device than the one selected in the Listening Device
frame. For the router and firewall modes, the device should be
the same as the one selected in the Listening Device frame.
If using the router or firewall mode, at the Device to send
block page pull-down menu, you may need to choose the
network card that will be used to send the block page to
client PCs.
NOTES: After making all selections in this window, click Apply.
The LAN IP address saved for the Device to send block page will
display in the IP field at the bottom of the Administrator console.
8 6 T , R3000 E
E ECHNOLOGIES
G
LOBAL
F U G
NTERPRISE ILTER SER UIDE
A S
DMINISTRATOR ECTION
C 1: S
HAPTER YSTEM SCREEN
161