Using Only One R3000 On The Network; Using More Than One R3000 On The Network; Set Up An R3000 To Be A Source Server - 8e6 Technologies R3000 User Manual

Using Only One R3000 on the Network

By default, the "Stand Alone" mode is selected in the Mode
frame. This indicates that all settings on the R3000 server
that is currently being configured apply only to that R3000.
For the Stand Alone mode setting:
1. In the Mode frame, click "Stand Alone".
2. Click Apply.

Using More than One R3000 on the Network

Using the synchronization process, all target servers are
updated with profile/library setting changes, so that no
matter which R3000 server the user's client PC accesses,
the user's Internet session will be appropriately filtered and
blocked.
NOTE: With synchronization activated, changes made to the
library will be transmitted from the source server to the target
server(s), but will not be automatically applied. Changes are
applied to a target server only under the following circumstances:
• The library is reloaded on the target server
• The Sync All button is clicked on the source server
• The library is updated via the Manual Update window

Set up an R3000 to be a Source Server

An R3000 configured to be a "source" server will send
profile/library setting changes to other R3000 ("target")
servers.
WARNING: If an R3000 server is set up in the Source mode with
a Network Address Translation (NAT) device between the source
and target server(s), be sure that ports 26262, 26268, and 88 are
open on the source server. This setup is required so that the
source server can communicate with the target server(s).
8 6 T , R3000 E
E ECHNOLOGIES
G
LOBAL
F U G
NTERPRISE ILTER SER UIDE
A S
DMINISTRATOR ECTION
C 1: S
HAPTER YSTEM SCREEN
147