Preparing For Installation; Installation Safety - Ruijie RG-AP530-I V2 Series Installation And Reference Manual

2 Preparing for Installation

Precautions
To prevent device damage and bodily injury, please read carefully the safety recommendations described in this
chapter.
The recommendations do not cover all possible hazardous situations.

Installation Safety


Do not expose the AP to high temperature, dusts, or harmful gases.

Do not install the AP in an inflammable or explosive environment.

Keep the AP away from EMI sources such as large radar stations, radio stations, and substations.

Do not subject the AP to unstable voltage, vibration, and noises.

Keep the AP in a dry location at least 500 meters away from the seaside and do not face it toward the wind from the
sea.

The installation site should be free from water flooding, seepage, dripping, or condensation.

The installation site should be selected according to network planning and features of communication devices, and
considerations such as climate, hydrology, geology, earthquake, electric power, and transportation.
Please follow the correct method described in the installation guide to install and remove the device.
2.1 Movement

Avoid moving the device frequently.

Turn off all power supplies and unplug all power cables before you remove the device.
2.2 EMI

Please observe local regulations and specifications when performing electrical operations. Relevant operators must
be qualified.

Please carefully check for any potential danger in the working area, for example, damp/wet ground or floor.

Find out the location of the emergency power supply switch in the room before installation. First cut off the power
supply in case of an accident.

Be sure to make a careful check before you shut down the power supply.

Do not place the device in a damp/wet location. Do not let any liquid enter the chassis

Keep the AP far away from the grounding or lightning protection devices of power equipment.
·