System Debugging; Setting Up A Debugging Environment; Powering Up The Ap - Ruijie RG-AP530-I V2 Series Installation And Reference Manual

4 System Debugging

4.1 Setting up a Debugging Environment

Use a power adapter or PoE to power the AP.
Setting up the Environment

Verify that the AP is properly connected to the power source.

Connect the AP to an AC through a twisted pair cable.

When the AP is connected to a PC for debugging, verify that the PC and PoE switch are properly grounded.

4.1.1 Powering up the AP

4.1.1.1 Checking before power-up

Verify that the power supply is properly connected.

Verify that the input voltage matches the specification of the AP.
4.1.1.2 Checking after power-up (recommended)
After powering up, it is recommended that you check the following to ensure normal operation of the AP.

Check if any message is printed on the Web-based configuration interface of the AC.

Check if the LED works normally.
·