MAXINCOM MUC1004 Administrator's Manual page 80

External Refresh
Interval
External host
NAT mode
RTP Port Start
UDP port
TCP port
TLS port
TLS Verify Server
TLS Ignore
Common Name
TLS Verify Client
TLS Client Method
Http://www.maxincom.com
MUC1004/2008/2016 Administrator guide
Used to identify the local network using a network
number/subnet mask pair when the system is behind a
NAT or firewall.
Some examples of this are as follows:
"192.168.0.0/255.255.0.0": All RFC 1918 addresses are
local networks;
"10.0.0.0/255.0.0.0": Also RFC1918;
"172.16.0.0/12":Another RFC1918 with CIDR notation;
"169.254.0.0/255.255.0.0": Zero conf local network.
Please refer to RFC1918 for more information.
Alternatively you can specify an external host, and the
system will perform DNS queries periodically. This setting
is only required when your public IP address is not
static. It is recommended that a static public IP address is
used with this system. Please contact your ISP for more
information.
Global NAT configuration for the system; the options for
this setting are as follows:
Yes = Use NAT. Ignore address information in the
SIP/SDP headers and reply to the sender's IP
address/port.
No = Use NAT mode only according to RFC3581.
Never = Never attempt NAT mode or RFC3581 support.
Route = Use NAT but do not include report in headers.
Beginning of RTP port range
Port used for SIP registrations, Default is 5060
Port used for SIP registrations, Default is 5060
Port used for SIP registrations, Default is 5061
When using PBX as a TLS client, whether or not to verify
server‟s certificate. It is "No" by default.
Set this parameter as "No", then common name must be
the same with IP or domain name.
When using PBX as a TLS server, whether or not to verify
client‟s certificate. It is "No" by default.
When using PBX as TLS client, specify the
protocol for outbound TLS connections. You can select
it as tlsv1, sslv2 or sslv3.
80 / 112