Layout Diagram - ADJ 6-PACK SKB CASE User Instructions

Element HexIP Pearl
WiFly On/Off and Wireless Addressing:
This function is used to activate the WiFly control and set the WiFly
address.
NOTE: The address must match the address that is set to WiFly
TransCeiver or WiFly controller.
1. Plug the fixture in and press the MODE button until "rCXX" is
displayed. You are in wireless set up mode.
2. Press the UP or DOWN buttons the UP or DOWN buttons to turn
the Wireless "On" or "Off".
3. Press the SET UP button to enter the Wireless address menu. Use
the UP or DOWN buttons to select your desired Wireless address.
Activate IR Sensor:
This function is used to activate and deactivate the IR sensor. When
this function is activated you can control the fixture using the UC IR or
Airstream IR App. Please see page 31 for controls and functions.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "IrXX" is displayed. "XX" represents
either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
Slave Setting:
1. Plug the fixture in and press the MODE button until "SLAv" is
displayed. The unit now designate a "Slave" unit in a Master-Slave
set up.
Default Running Mode:
This is a default running mode. When this mode is activated all modes
will return to their default settings.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the
MODE button to exit.
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 29
Operating Instructions
Element HexIP Pearl
1
1. Battery On/Off Switch: This switch is used to activate the battery
power. You must also activate the LOAD function. See page
23 "Load Setting" to activate.
2. Kickstand: This kickstand is used to angle the unit to various
degrees. There are 3 different degree levels. Note: Be very
cautious at the degree in which you angle the unit at, due to
the fact that it could fall over.
3. Power Input & Fuse Holder: This input is used to connect the
included I.E.C. power cord. After connecting the power
cord, plug the other end into a matching power source.
Located inside the power socket is the fuse housing. See
page 36 for fuse replacement.
4. Mode Button: This button lets you scroll through the system menu.
Setup Button: This button lets you Enter submenu's.
Up & Down Button: These button's are used to scroll through
submenu's and make adjustments in the submenu's
5. Digital Display: This will display the various menu's, submenu's,
and adjustments.
6. Control Panel Access Door: Lifting this door will allow you to
access the controls and functions.
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 10

Layout Diagram

6
5
4
3
2