Battery Replacement - ADJ 6-PACK SKB CASE User Instructions

Element HexIP Pearl
The UC IR (sold separately) infrared remote gives you control of
various functions (See below). To control the fixture you must aim the
remote at the front of the fixture and be no more than 30 feet away.
To use the ADJ UC IR you must first activate the fixtures infrared sen-
sor, to activate the sensor please see the instructions on page 29.
The Airstream IR (sold separately) remote transmitter plugs into the
headphone jack of your iOS phone or tablet. To control your IR fixture
you must raise the volume to the maximum on your iOS phone or tab-
let and aim the transmitter at the fixture sensor and be no more than
15 feet away. After you have purchased the Airstream IR transmitters,
the app is a free download from the app store for your iOS phone
or tablet. The app comes with 3 pages of control depending on the
fixture you are using. Please see below for IR functions including the
corresponding app page.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture. Press the button
again to return to the initial state.
FULL ON - Press this button to fully light up the unit.
FADE/GOBO - This button activates color change mode, color fade mode
and color chang/fade mode. Each press of the button will cycle through the
modes.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output in-
tensity in color mode.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust
the strobe speed. "1" being the slowest, "4" being the fastest.
COLOR - Press this button to activate color mode. Use buttons 1-9 to find
your desired color.
1-9 - Use buttons 1-9 to select your desired color in static color mode or
your desired color fade mode and color change mode. In color fade mode
and color change mode, press the Show 0 button to activate show 10. Press
the 1 button twice to activate show 11.
SOUND ON & OFF - Use the buttons to activate and deactivate sound ac-
tive mode.
SHOW 0 - See buttons 1-9.
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 31
UC IR & Airstream App Control
Element HexIP Pearl
area of contact immediately with fresh water and seek medical
attention immediately.
3.4 Do Not Expose the Battery to Heat or Fire
Never incinerate or dispose of the batteries in fire. This may
cause an explosion, which would be very dangerous.
3.5 Do Not Expose the Battery to water or liquids
Never soak/drop the batteries in liquids such as water, seawa-
ter, drinks such as soft drinks, juices, coffee or other.

3.6 Battery Replacement

For battery replacement please contact ADJ customer support
(800) 322-6337.
3.7 Do Not use a damaged Battery
The battery could be damaged during shipping, caused by
shock. Should the battery be found damaged, including dam-
ages to the plastic casing of the battery, deformation of the
battery package, smelling of an electrolyte, or leakage of the
electrolyte gel, or other, DO NOT use the battery. A battery with
a odor of electrolyte or a gel leakage should be placed away
from fire to avoid fire or explosion.
4. Battery Storage
When storing the battery, it should be stored at room tempera-
ture, with a charge of at least 50%. We recommend that during
long periods of storage that the battery be charged every 6
months. Doing this will prolong the life of the battery and will
also make sure that the battery charge does not fall below the
30% mark.
5. Other Chemical Reaction
Because batteries utilize a chemical reaction, battery per-
formance will deteriorate over time even if stored for a long
period of time without being used. In addition, if the various
usage conditions such as charge, discharge, ambient tempera-
ture, etc. are not maintained within the specified ranges, the
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 8
Battery Precautions