Battery Precautions; Battery Connection; Battery Status - ADJ 6-PACK SKB CASE User Instructions

Element HexIP Pearl
1. Handling of Batteries
1.1 Do Not Short Circuit the Battery
Try to never short circuit the battery. It generates a very high
current which could cause the battery to overheat which may
result in electrolyte gel leakage, harmful fumes, or explosion.
The LIR tabs may easily short-circuit by placing them on con-
ductive surface. A short circuit may lead to heat build up and
damage of the battery. An appropriate circuitry with PCM is
employed to protect accidental short circuit of the battery pack.
1.2 Mechanical shock
Droping the unit, impact hit, bending, etc. may cause failure or
shortend life of the LIR battery.
3. Other

3.1 Battery connection

1). Direct soldering of wire leads or devices to the battery is
strictly prohibited.
2). Lead tabs with pre-soldered wiring shall be spot welded to
the batteries. Direct soldering may cause damage of compo-
nents, such as separator and insulator, by heat build up.
3.2 Prevention of short circuit within a battery pack
There is enough insulation layers between wiring and the bat-
teries to provide extra safety protection. The battery pack is
constructed in a way that no short circuit will occur which may
cause smoke or fire.
3.3 Do No Disassemble the Batteries
1). Never disassemble the batteries.
Doing this may cause a internal short circuit in the battery,
which may lead to harmful fumes, fire, explosion, or other prob-
lems.
2). Electrolyte Gel is harmful
Electrolyte Gel should not leak from the LIR battery. Should the
electrolyte gel come into contact with the skin or eyes, flush the
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 7

Battery Precautions

Element HexIP Pearl

Battery Status:

This function is used to check the life status of the battery.
Plug the fixture in and press the MODE button until "bXXX" is
displayed. "XXX" represents the current battery life. The num-
ber that is displayed is the remaining battery life. If "b---" is
displayed, it means that you are running the unit on AC power.
Please do not let the battery fully die, this severly shortens
the life of the battery.
NOTE: When the battery life is below 30% the battery percent-
age will flash. At 15% power the fixture will shut off.
NOTE: When using battery power, after 20 seconds of inac-
tivity, the display will revert back to the battery life display.
Battery Recharge: To recharge the battery, plug the supplied
AC cord into the AC input on the side of the unit and plug the
other end into a matching power supply. It takes about 4 hours
to reach full charge (with the power off). The display will STOP
flashing when the unit reaches 100% charge.
Note: When unplugging the unit from charging and then
applying power via battery, there will be a minimal charge
drop.
For a faster recharge, turn the Load setting to "Off" and turn the
battery "On". See LOAD SETTING on page 23.
ADJ Products, LLC - www.adj.com - Element HexIP Pearl User Manual Page 32
Battery Status & Charging