Aed Modes - Cardiac Science POWER2HEART AED G3 Automatic 9300A Operation And Service Manual

AED MODES

Operating Mode: Defined as having the battery installed and the lid open. This is the mode the AED would be
in during an actual rescue situation.
Standby Mode: When the battery is installed, but the lid is closed. In this mode the AED is not being used in a
rescue. The device will conduct its routine self-tests to ensure proper operation.
Storage Mode: When the battery is removed, such as during shipping or transport. With the battery removed,
the AED is unable to perform self-tests or rescues.
ENVIRONMENTAL OPERATING AND STANDBY CONDITIONS
See Section 7 – Technical Data, Parameters, Environmental Operation and Standby Conditions on page 48.
CAUTION: Temperature Extremes
Exposing the AED to extreme environmental conditions outside of its operating parameters may
compromise the ability of the AED to function properly. The RescueReady
impact of extreme environmental conditions on the AED. If the daily self-test determines environmental
conditions outside of the AED's operating parameters, a "SERVICE REQUIRED" alert will be issued
to prompt the user to move the AED to environmental conditions within the acceptable operating
parameters at once. See Section 7 – Technical Data, Parameters, Operation and Standby Conditions
on page 48.
SHIPPING AND TRANSPORT CONDITIONS
(For up to 1 week)
See Section 7 – Technical Data, Safety and Performance Standards/Shipping and Transportation Conditions on
page 52.
© 2003-2004 Cardiac Science, Inc. All rights reserved.
Section 3 - Getting Started
® daily self-test verifies the
112-2025-005 Rev B page 23