Scheduled Maintenance - Cardiac Science POWER2HEART AED G3 Automatic 9300A Operation And Service Manual

SCHEDULED MAINTENANCE

DAILY MAINTENANCE
For the Powerheart AED, check the STATUS INDICATOR to ensure that it is GREEN . When the
indicator is GREEN , the Powerheart AED is ready for a rescue. If the indicator is RED , refer to
the Troubleshooting Table in this chapter.
MONTHLY MAINTENANCE
1. Open the AED lid.
2. Wait for the AED to indicate status:
If so equipped observe the change of the STATUS INDICATOR to RED . After approximately
5 seconds, verify that the STATUS INDICATOR returns to GREEN .
3. Check the expiration date on the electrodes.
4. Listen for the voice prompts.
5. Close the lid and confirm that STATUS INDICATOR remains GREEN .
ANNUAL MAINTENANCE
Perform the following tests annually to confirm that the diagnostics are functioning properly and to verify the
integrity of the case.
Check the Integrity of the Pads and Circuitry
1. Open the AED lid.
2. Remove the pads.
3. Close the lid.
4. Confirm that the STATUS INDICATOR turns red, (for Powerheart AED only).
5. Open the lid and confirm that the PAD indicator is lit.
6. Reconnect the pads and close the lid.
7. Make sure the expiration date is visible through the clear window of the lid.
a. For the Powerheart AED G3, check to make sure that the STATUS INDICATOR
is GREEN.
b. For the FirstSave AED G3, open the lid and check to make sure the PAD
indicator LED is NOT lit. If the pads are not installed properly, the PAD
indicator will illuminate; call Customer Service for assistance.
8. Open the lid and confirm that no diagnostic indicators are lit.
9. Check the expiration date of the pads; if expired, replace them.
10. Check the pads packaging integrity.
11. Close the lid.
© 2003-2004 Cardiac Science, Inc. All rights reserved.
Section 6 - Maintenance & Troubleshooting
112-2025-005 Rev B page 43