Table of Contents
Advertisement
FX-20P-E Handy programming panel
Example: Input by FNC No. (example of "[D]MOV[P] D0 D2")
Display example
In the step 9)
W
• Using the ASC instruction, ASCII characters can only be read and not written. For writing
ASCII characters, use the software A6GPP/A6PHP .
• An error will occur if an application instruction is not supported in the used PLC.
• Press the [FNC] and [HELP] keys in this order to display classified items of application
instructions on screen. These classification items 0 to 24 are set on seven screens, and the
screens can be scrolled by the cursor control keys.
• Among the classified items, select a desired item by using the number keys. Input a number
in the order "100's digit, 10's digit and 1's digit". When the 10's digit is entered, instructions
whose 10's digit is the input number are displayed on the screen.
Only application instructions valid in the used PLC are displayed in the list.
Scroll the screens by using the cursor control keys, then entered a number for the 1's digit.
By the operation above, the application instruction No. is specified.
Then, input an operand consecutively.
Key operation
1)
Write function
200
DMOVP
D
0
D
2
2)
FNC
209
NOP
3)
D
4)
P
5)
S'P
6)
D
0
7)
S'P
1
2
8)
D
2
9)
GO
Write 5
5-8
Advertisement
Table of Contents
