Table of Contents
Advertisement
FX-20P-E Handy programming panel
2.
Startup Procedure
2.1
Startup procedure
Connect the HPP to the
PLC, power PLC ON.
Screen
display
COPYRIGHT(C)1990
MITSUBISHI
ELECTRIC CORP
MELSEC FX V4.10
PROGRAM MODE
ON LINE (PC)
OFF LINE (HPP)
• While the power from the PLC is OFF, connect the HPP to
the PLC.
• If the power from the PLC is turned ON while the [RD/WR]
key on the HPP is pressed, the PLC starts up in the STOP
status even if the PLC RUN input is ON, and becomes
ready for programming.
(Only FX, FX
When the power of the PLC is turned OFF once then
turned on again, the RUN status of the PLC is valid. (The
RUN status is not valid by changeover from STOP to
2 seconds
later
RUN.)
• In the initial status, the cursor is located in "ONLINE (PC)".
Select a desired program mode by pressing the [↑] or [↓]
key, then press the [GO] key to proceed to the next screen.
, FX
, FX
and FX
2C
0
0S
0N
Startup Procedure 2
are possible)
2-1
Advertisement
Table of Contents
