FX-20P-E Handy programming panel
Parameter setting condition
PLC
RUN:×
status
• Set the PLC to the STOP status before changing parameters in the online mode.
• When using the EEPROM cassette, set the write-protect switch to OFF before changing
parameters in the online mode.
• When using the EPROM cassette, parameter change is disabled in the online mode.
10.5.2
Default setting
• Initialize the parameters.
Display example
4.PARAMETER
DEFAULT SETTING?
YES
STOP:✓
Valid memory
- When setting the default values (initial values), place the
cursor on "YES" and press the [GO] key.
When not setting the default values, place the cursor on
"NO" (initial status) and press the [GO] key. By this
NO
operation, the memory capacity setting screen appears.
Inbuilt memory:✓
RAM cassette:✓
Others Function 10
EEPROM
EPROM
cassette:
cassette:×
10-10