Module (Offline Mode) - Mitsubishi FX-20P-E Operation Manual

FX-20P-E Handy programming panel
10.9

Module (offline mode)

• When the ROM writer module (FX-20P-RWM) is connected to the HPP , programs can be transferred
between the inbuilt HPP RAM and the memory cassette attached to the FX-20P-RWM.
• The HPP automatically identifies the attached special module.
• The module function is available only in the offline mode.
• When using the FX
the STOP status. (The FX-20P-RWM cannot be connected while the PLC is in the RUN status.)
• When using the FX
• When using the FX-2PIF, the FX-20P-RWM can be connected.
(If the FX-20P-RWM is connected while the FX
the FX /FX
1S 1N
/FX Series PLC, the FX-20P-RWM can be connected only while the PLC is in
0 0S
/FX Series PLC, the FX-20P-RWM cannot be connected.
1S 1N
Series PLC or the FX-2PIF, the power capacity supplied from the PLC is insufficient.)
/FX Series PLC is in the RUN status or connected to
0 0S
•Access between the HPP and the module
HPP
Inbuilt
RAM
1)Write: Writes the contents saved in the inbuilt HPP RAM
to the EPROM or the EEPROM attached to the
FX-20P-RWM.
2)Read: Reads the contents saved in the EPROM or the
EEPROM attached to the FX-20P-RWM to the
inbuilt HPP RAM.
3)Verify: Collates the contents saved in the inbuilt HPP
RAM with the contents saved in the EPROM or
the EEPROM attached to the FX-20P-RWM.
Others Function 10
FX-20P-RWM
1)
EPROM
2)
3)
EEPROM
10-22