Table of Contents
Advertisement
FX-20P-E Handy programming panel
From the previous page
When the
GO
online mode
is selected
SELECT PC TYPE
ON LINE MODE FX
SELECT FUNCTION
OR MODE
MEM. SETTING 8k
(p.t.o)
When the offline
mode is selected
FX, FX0
FX2N,FX1N,FX1S
GO
When the offline mode
is selected, "OFF LINE
MODE" is displayed.
• When the online mode is selected, the HPP
automatically discriminates the PLC model, and
proceeds to the function selection screen.
If the entry code has been registered in the PLC,
the HPP proceeds to the entr y code input
screen. (Refer to 10.5.4.)
• When the offline mode is selected, select the PLC
model by pressing the [↑] or [↓] key, then press
the [GO] key to proceed to the next screen.
At this time, if the selected model is different from
the stored model, the following screen appears.
1. OFF LINE MODE
EXECUTE?
OK→[GO]
NO→[CLEAR]
- Press the [GO] key to register the selected
model to the parameter (initial value), then
proceed to the mode selection screen.
- Press the [clear] key to return to the program
mode selection screen.
When using the FX
1S
program capacity to 2k steps by setting the
parameter as described later. (Refer to 10.5.3.)
Startup Procedure 2
Series PLC, change the
2-2
Advertisement
Table of Contents
