How To Do An Autotest Through A Poe Device - Fluke DSX-600 Technical Reference Handbook

DSX-600 CableAnalyzer
Technical Reference Handbook
Turn off the AC wire map test if the PoE device supplies power

on pairs 4,5 and 7,8. In those devices, the inputs and outputs
are fully isolated on those pairs. To do tests through those
devices, use a PoE test limit such as POE 2-Pair Cat 6 Perm.
Link. The PoE limits are in the Application group on the TEST
LIMIT screen.

How to Do an Autotest Through a PoE Device

1 Turn on the AC Wire Map test.
2 Make sure that the other settings shown on the home screen
are correct.
3 Connect to the cabling as shown in Figure 47 for a permanent
link or Figure 48 for a channel
4 Make sure that the PoE device is turned off.
5 Do an Autotest as described on page 87.
98