Pairing A Remote Control - Viper 4811V Owner's Manual

Pairing a Remote Control

Pairing a remote control is a process whereby the remote control and the system in the vehicle learn each
other's encrypted identification, securing their communication from intruders. Please note the remote control(s)
come already paired from the factory. These instructions can be used if reprogramming or adding a new
remote control to the system. The following instructions steps you through pairing the 2-way and 1-way remote
control(s).
Note: Both the remote control and the vehicle need to be setup to pair a remote to the system and the remote
must be set to the desired Car1 or Car2 mode. (see Owners Manual for more details about selecting vehicles).
LCD 2-Way Remote Control:
1. Press and hold the
displayed on the screen. Release the
2. Press and release the
3. Press and hold the
now ready to pair with the system.
Vehicle Setup for Pairing:
• Turn ON the vehicles ignition to the RUN position.
• Within 5 seconds press and release the Control Center button on the Control Center one time then
press it once more and hold it.
• The Control Center LED begins flashing in a single flash pattern and the horn will sound once to
confirm the system is in pairing mode.
• Now release the Control Center button.
4. With both the remote and system in pairing mode, press the
5. The siren chirps to indicate the system has learned the remote ID and is sending its ID to the 2-way
remote.
6. The LCD remote control will indicate a Successful or Failed pairing. If pairing fails, the remote
will go back to the Remote Pair screen, press the
pairing. Once the remote has paired to the system Successful will display on the remote screen and it
will also emit several tones to confirm.
7. Once the pairing is completed turn OFF the ignition in the vehicle, the siren will sound to confirm
exiting.
8. When both the system and remote have exited the Pairing mode, you may now test for functionality.
To exit Pairing Mode on the remote:
• Wait 30 seconds without pressing a button on the remote.
• Press and release the
To exit Pairing Mode on the system:
• Turn OFF the ignition.
• Wait 60 seconds for the system to automatically exit.
• The horn (if connected) will sound to confirm exiting.
LED 2-way or 1-way Remote Control:
1. Press and hold the
on solid, release the
2. Press and hold the
The remote is now ready to pair with the system.
24
button on the remote for 8 seconds, the remote beeps once,
button.
button until Remote Pair is displayed on the screen.
button or the
button until the remote beeps 3 times then release the
button on the remote.
button on the remote for 8 seconds. The transmit LED on the remote will come
button.
button on the remote until the transmit LED flashes 3 times then comes on solid.
button on the remote.
button on the remote again to attempt another
Main Menu
is
button. The remote is
© 2015 Directed. All rights reserved.